POLE MOUNT ASSEMBLY BASIC: HOW TOROIDAL WORKS The illustration shows how signal travels through Toroidal. Signals are reflected twice; 1 on the main reflector and 2 on the sub reflector. This is how Toroidal can capture multiple signals within 40 degrees in arc. [In other words, you can capture satellites from 90W ~ 130W or 60W ~ 100W or 110W ~ 150.]...
Page 5
BEFORE ALIGNMENT PROCESS Check Your Assembly (Sub Reflector) Follow the assembly diagram to assemble your Toroidal. Check the orientation of your sub reflector and guide as illustrated on the figure. (O) is the correct assembly of sub reflector. Check Your Assembly (Back Mount Unit) Check the orientation of back mount unit as illustrated on the figure.
Page 6
If you have not received the information, please request your zip code specific information at the “Setup Info” section on www.WaveFrontier.US. Assemble holder parts by hand at this stage. Adapter will be required if neck size of your LNBF is less than 40 mm.
Page 7
PRE-ALIGNMENT: TOROIDAL ELEVATION Tip: You will be making adjustment on elevation, skew and azimuth angles when optimizing your setup throughout the process. Do not use excessive force when assembling moving parts. VERY IMPORTANT: Make sure that your pole mount absolute vertical position.
Page 8
ALIGNMENT: TOROIDAL If possible, align Toroidal on the ground level with your receiver and monitor right next to Toroidal. (or use a sat finder equipment). It is MUCH FASTER, EASIER and SAFER. AZIMUTH SETTING 1. Connect your receiver to the center LNBF (closest one to the center).
Page 9
FINE-TUNING: TOROIDAL The alignment process of Toroidal is to adjust two lines in parallel. Assume that “A” line is formed by your LNBFs and “B” line is formed by your target satellites. The alignment process of Toroidal is to make these two lines parallel. In reality, the line B is not a straight line.
Page 10
Your Toroidal comes with 1 year manufacturer’s limited warranty. To ensure your warranty coverage, you must do the followings: 1. REGISTER YOUR TOROIDAL Visit www.WaveFrontier.US Logo on to REGISTER section Provide all required information 2. KEEP SERIAL NUMBER Please take off the serial number label and place this on the back of MAIN REFLECTOR.