Thermal Cutout(Tco's); Oven Thermal Cutout (Flame Sensor); Replacement Of Flame Sensor - Electrolux LEVM30FE Service Manual

5-9 THERMAL CUTOUT(TCO'S)

There are 4 different thermal cutouts in this unit with 4 different purposes. They are :
1. Oven thermal cutout (flame sensor), on cavity top.
2. Hood thermal cutout, inside control area on duct.
3. Bottom thermal cutout, on floor of control area.
4. Magnetron thermal cutout, on magnetron.

5-9-1 Oven Thermal Cutout (Flame sensor)

The oven thermal cutout(Cavity TCO) is located
on the top side of the oven cavity beside exhaust
duct with a temperature rating of 320°F(160°C)/
140°F(60°C).
The cutout is tightly held to the top of the oven
cavity by duct-upper.

5-9-2 Replacement of Flame Sensor

Disconnect oven power. Remove Grille & Panel-outer.
1. Remove screws securing the duct upper.
2. Loft up the exhaust duct from the cavity.
3. Disconnect two wire leads.
T.C.O
OVEN THERMAL CUTOUT
- 17 -