1. Manuals
  2. Brands
  3. ACR Heat Products Manuals
  4. Stove
  5. Malvern MV1MF
  6. Technical manual

ACR Heat Products Malvern MV1MF Technical Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
TECHNICAL MANUAL
Malvern
Multifuel Stove
Model MV1MF
To be retained by the user for future reference
Serial Number ..................................
Document MV1MF 0101
Version 1 Date 17/10/13
Thank you for purchasing an ACR Heat Products stove.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Malvern MV1MF and is the answer not in the manual?

Questions and answers

Related Manuals for ACR Heat Products Malvern MV1MF

Summary of Contents for ACR Heat Products Malvern MV1MF

  • Page 1 TECHNICAL MANUAL Malvern Multifuel Stove Model MV1MF To be retained by the user for future reference Serial Number ……………………………. Document MV1MF 0101 Version 1 Date 17/10/13 Thank you for purchasing an ACR Heat Products stove.
  • Page 2  The appliance must not be modified in anyway unless authorized by ACR Heat Products Ltd.  The appliance should be inspected regularly to ensure the airways are clean and free from obstruction and the chimney swept at least once a year.
  • Page 3 MALVERN SPECIFICATIONS Nominal heat output ………… 5.2 kW – WOOD 4.8 kW – SMOKELESS FUEL Chimney draft required ……… 12Pa Height …………………………… 535 mm Width ……………………………. 445 mm Depth …………………………..285 mm Weight …………………………… 80 kg Air Requirement ……………….. N/A *** Flue Mass Gas Flow ……………...
  • Page 4 MV1MF Dimensions...
  • Page 5 The Clean Air Act 1993 and Smoke Control Areas Under the Clean Air Act local authorities may declare the whole or part of the district of the authority to be a smoke control area. It is an offence to emit smoke from a chimney of a building, from a furnace or from any fixed boiler if located in a designated smoke control area.

  • Page 6: Installation Instructions

    Installation Instructions CO Alarms It is required by building regulations that whenever a new or replacement wood/solid fuel or biomass appliance is installed in a dwelling a carbon monoxide alarm to BS EN 50292:2002 must be fitted in the same room as the appliance.
  • Page 7 Hearth Requirements The appliance must stand on a level fireproof hearth with a minimum thickness of 12mm. The hearth temperature created by this stove is below 100˚C. The hearth must protrude at least 300mm in front of the appliance and 150mm either side of the appliance. The appliance shall be installed on a floor with an adequate load bearing capacity.

  • Page 8: Assembly Of The Unit

    Assembly of the unit This appliance is equipped with a manufactures smoke exempt stop pre – fitted, under no circumstances should it be tampered with or removed unless expressly authorized by a competent person The appliance is supplied pre-assembled with the flue spigot in the top exit position.
  • Page 9 Maintenance The chimney should be swept at least once a year together with the flue pipe connection. Care should be taken to ensure that there is not a build up of soot on the baffle and in the airways of the appliance. If the appliance has not been operated for long periods, the flue should be inspected and swept before use to ensure there are no blockages within the flue.

  • Page 10: User Instructions

    User Instructions Please note that during the first firing, we recommend a small fire is lit and that you slowly increase the temperature to enable the various parts to expand normally. You may also experience fumes and a haze being given off by the stove during the first firing and possibly for the next couple of firings as the paint cures.
  • Page 11 Instructions for use with wood  Slide the top air control to the right and open the primary air fully by pulling the lever forward.  Lay firelighters or rolled up newspapers on the grate and add a small amount of kindling wood to the top. Place 1 or 2 small logs on the top. ...
  • Page 12 Fuel overloading Never overload the stove – it will work very well with two medium sized logs. The amount of fuel specified in this manual should not be exceeded, overloading can cause excess smoke. Operation with door left open Operation with the door open can cause excess smoke. The appliance must not be operated with the appliance door left open except as directed in the instructions.

  • Page 13: Troubleshooting

    Troubleshooting Problem Probable Cause Action Recommended Fire difficult to Green wood / wet wood Use hardwood logs Start / Fire goes with a maximum moisture content of 20% Logs are too large Use kindling and small logs to start the fire and once established use split logs Not enough primary air...

  • Page 14: Commissioning Check List

    Commissioning Check List (Please mark box when completed) Ensure the serial number has been recorded on the front of this manual for any future use Ensure the door seals are in good condition and that the glass is secured correctly in the door (do not over tighten the glass as this will prohibit its expansion and could cause the glass to crack) Ensure that all internal components are fitted correctly (these may have shifted in transit)
  • Page 18 SPAREPART LIST STOVE-K4221 MALVERN Position Quantity Description Part number burning chamber door complete 8400-314 hinge 9900-972A flue spigot 3490-047 flue spigot gasket (8x3) 1982-004 9900-1258B linea spring 6536-018 primary air regulator 5311-645A door cover plate 9900-993 adjustable feet 4300-949 blanking plate 4111-136 secondary air box 9900-971B...
  • Page 19 Commissioning Check List (Please mark box when completed) Ensure the serial number has been recorded on the front of this manual for any future use Ensure the door seals are in good condition and that the glass is secured correctly in the door (do not over tighten the glass as this will prohibit its expansion and could cause the glass to crack) Ensure that all internal components are fitted correctly (these may have shifted in transit)

  • Page 20: Warranty Certificate

     Baffle plates Your statutory rights are not affected by this warranty. In the event of a warranty claim, please return the form overleaf to ACR Heat Products Ltd, Unit One, Weston Works, Weston Lane, Tyseley, Birmingham, B11 3RP, UK.
  • Page 21 Warranty Claim Form Customer Name: ……………………………………………………………………… Customer Address: ……………………………………………………………………. ……………………………………………………………………………………………… ……………………………………………………………. Postcode …………………. Daytime Tel: ……………………………. Mobile Tel: ……………………………… Model Name: …………………………… Model Number: ………………………. Serial Number: …………………………………………………………………………. Date of purchase: …………………………………………………………………….. Date of installation: …………………………………………………………………… Installer’s Name and address: ……………………………………………………… ………………………………………………………………………………………………...

Table of Contents