Related Manuals for brennenstuhl RCS 1000 N Comfort
Summary of Contents for brennenstuhl RCS 1000 N Comfort
- Page 1 Operating manual RCS 1000 N / GB Comfort Remote control set Item no. 1 50745 3 0418520/0708...
-
Page 2: Intended Use
SAFETY Intended use The devices which constitute this RF remote control switch set are intended only for personal use in closed dry rooms. They are not suitable for commercial use. The RF remote control switch set is used for switching lamps and electrical appliances on and off. -
Page 3: Waste Disposal
Do not cover the socket switches. Heat builds up under the • cover. This poses a fi re hazard. Regularly check the devices for damage. Do not replace dam- • aged parts. Contact the manufacturer or dispose of the devic- es in an environmentally friendly manner. -
Page 4: Scope Of Delivery
Batteries do not belong in the household rubbish. They may contain poisonous heavy metals and must be treated as hazardous waste. For this reason, take used batteries to a local collection point. DEVICE Scope of delivery: The following items are included in the scope of delivery: remote control with battery –... - Page 5 1 Socket switch 6 Function indicator light 2 Childproof Schuko socket 7 OFF keys (A, B, C, D) Schuko plug 8 Battery compartment Function indicator light cover 5 Remote control 9 ON keys (A, B, C, D) Preparations Before you can use the devices you must: insert the battery, –...
- Page 6 Press any key on the remote control (5). The function indica- tor light (6) illuminates when the key is pressed. If the function indicator light (6) does not light up when a key is pressed the device is not receiving any power from the battery.
- Page 7 Setting a radio channel on the socket switch 12 13 Undo the screw (16) of the cover (13) using a PH0 Phillips screwdriver. Slightly raise the cover (13) above the screw hole (12) and push out. Set the same radio channel as for the remote control using DIP switches 1 to 5 (14).
- Page 8 Assigning a socket switch to a control key Set a frequency of a control key on the remote control using DIP switches 6 to 9 (14): DIP switch 10 is not occupied. Control key DIP switch Push the cover in (13) and close. Insert the screw (16) through the screw hole (12) into the thread (15) and tighten.
-
Page 9: Connecting The Devices
Connecting the devices The remote control radio signal has a range of up to 25 m (dependent on structural conditions). The range can be affected by structural conditions (for example reinforced concrete), electrical conditions (for example electrical lines) or electromagnetic conditions (for example telephones). -
Page 10: Maintenance
CLEANING Caution! Risk of electric shock. Before cleaning the device disconnect it from the mains supply. Caution! Risk of electric shock. Ensure that no liquid penetrates into the device. Liquid which enters the device can cause short-circuiting. Caution! Risk of damage from aggressive cleaning agents. -
Page 11: Troubleshooting
TROUBLESHOOTING Fault Possible Remedy cause Function indicator Battery has been Insert battery light (4) does not inserted incor- correctly. light up when a key rectly. is pressed. There is no bat- Press down on tery contact. the battery termi- nals. Battery is empty. -
Page 12: Warranty
Service Hotline. Only then can your device be returned free of charge. The original warranty period shall not be extended by repair or replacement of parts. MANUFACTURER H. Brennenstuhl GmbH u. Co. KG Seestraße 1-3 72074 Tuebingen Germany Email: info@brennenstuhl.de Service Hotline: +49 (0) 180 5 720741 (14 cents/min.