Table of Contents
Advertisement
Connecting to the Monitoring Device
1 . Supply power to the Tap using the two redundant power supplies included
with the unit . Verify that the Power LED illuminates .
2 . Connect Monitor Port A to the appropriate port on the monitoring device
using a CAT5 straight-through cable .
3 . Connect Monitor Port B to the appropriate port on the monitoring device
using a CAT5 straight-through cable .
Note: _______________________________________________________________
The second power supply is available to support the flow of traffic to the
monitoring device in the event that the first power supply becomes
unavailable.
______________________________________________________________________
®
High Density Tap 10/100 Ethernet
Figure 6: Connecting to the Monitoring Device
4 . Repeat Steps 2-3 for each monitoring device you wish to connect to the
10/100 Multi-Station Tap .
1
2
3
4
5
A
A
2
B
B
1
Monitor
6
7
8
9
10
11
12
A
B
To monitoring device
To monitoring device
7
10/100 Multi-Station Tap
13
14
15
16
17
18
A
A
B
B
19
20
Advertisement
Table of Contents
