• Capacity: – Circular (90°) – 3.3" (85mm) – Rectangular (90°) – 3.3 x 4.1" (85 x 105mm) – Circular (45°) – 2.7” (70mm) – Rectangular (45°) – 2.5 x 2.9" (65 x 75mm) Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Page 3
With this powerful Eastwood Benchtop Band Saw you will be able to cut materials for most anything in auto repair, general fabrication or other projects. The high performance, variable speed motor drives the blade at 100-260 feet per minute. The pivoting clamp allows for miter cuts from 90° to 45°.
– Powder Like Chips → Increase Feed – Curled Silver Chips → Ideal Feed and Speed Material Blade Speed (ft/min) Low Carbon Steel High Carbon Steel Chromoly Steel Tool Steel Cast Iron Aluminum 100-125 Squares/Rectang Wood Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Page 5
Squares/Rectangles I-Beams Squares/Rectangles I-Beams Knock Off Sharp Edge Here With A File Rounds Channels Angles Knock Off Sharp Edge Here With A File gles I-Beams Hexagonals Tees To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 6
11. Replace the Blade Guard. Be sure to install the cover so that the blade is covered. 12. Reposition the Blade Guide in the proper position for the next cut. 13. Follow the blade run in procedure. FIG. D Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
- Adjust Tension. See section on “Adjusting the Blade Tension”. • Does not cut or slow cutting: - Replace Blade. See section on “Replacing the Blade”. ADDITIONAL AVAILABLE ITEMS • #20238 Replacement Blade To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 8
If you have any questions about the use of this product, please contact Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/20237manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...
Need help?
Do you have a question about the 20237 and is the answer not in the manual?
Questions and answers