Setting The Operating Mode; Preset Mode - Decibel Eleven Dirt Clod Features And Operation

preset. Pressing 'A' while 'B' is active will switch 'A' on and switch 'B' off, and vice-

versa. In BANK mode, the 10 user presets are accessed in 5 banks of 2 presets, and

the current bank number will be displayed. In order to change banks, press and hold

the DIRT knob and then press 'B' to increment the bank, and 'A' to decrement the

bank.

In PRESET mode, the 'B' footswitch is used to enable or bypass the preset, and the 'A'

footswitch is used to scroll through the available preset numbers. When the Dirt Clod is

bypassed, the display will show the pending preset number. Press the 'A' footswitch to

change the pending preset until the desired preset number is displayed. Press the 'B'

footswitch to enable the displayed preset.

Once a preset is enabled, you can use the 'A' footswitch to go directly to another preset

without bypassing. Use the 'A' footswitch to select the next desired preset number.

Notice that the decimal point will be displayed to indicate that the displayed preset

number is pending (not active). Press the 'B' footswitch to activate the displayed

preset.

In order to more effectively manage scrolling in PRESET mode, it is possible to set a

limit on the number of presets used. This cuts down on the need to scroll through

unused presets. For example, if you are only using 3 presets, then in preset mode you

can use the 'A' footswitch to scroll 1, 2, 3, 1, 2, 3, etc. See the section below for setting

the preset limit.

Setting the operating mode

The Dirt Clod is initially set to PRESET mode. To change the mode settings, disconnect

the power from the pedal. Press and hold the 'B' footswitch while applying power to the

pedal. The display will indicate the current mode setting, '

' (PRESET) or '

'.(BANK).

Use the 'A' and 'B' footswitches to change this setting as desired.

To change the preset limit when using PRESET mode, first select PRESET mode such

that the display shows '

'. Then, press the DIRT knob to display current preset limit.

Turn the DIRT knob to change the limit from 2 to 0 (0=10). For example, setting the

preset limit to 4 will limit PRESET mode access to only presets 1-4.

Exit by disconnecting power. Your settings will be saved.

MIDI

There are two ways that the Dirt Clod can be controlled via MIDI.

Table of Contents