Servicing Procedures - Jeep Renegade Owner's Handbook Manual

151
SERVICING
PROCEDURES
176) 177) 178)
64) 65) 66) 67) 68) 69) 70) 71)
WINDSCREEN/REAR
WINDOW WIPER
Replacing the windscreen
wiper blades
Proceed as follows:
❒ raise the wiper arm, press tab A fig.
152 of the attachment spring and
remove the blade from the arm;
A0K0530C
152
❒ fit the new blade, inserting the tab in
the dedicated housing in the arm and
checking that it is locked;
❒ lower the wiper arm on the
windscreen.
IMPORTANT Do not operate the
windscreen wiper with the blades lifted
from the windscreen.
Replacing the rear window
wiper blade
Proceed as follows:
❒ raise cover A fig. 153, undo nut B
and remove arm C;
❒ correctly position the new arm, fully
tighten the nut B then lower the cover
A.
153
IMPORTANT Do not operate the rear
window wiper with the blade lifted from
the rear window.
Windscreen washer
The windscreen jets, located on the
J0A0345C
bonnet, are fixed.
If there is no jet of fluid, firstly check
that there is fluid in the reservoir (see
paragraph "Engine compartment"
in this chapter). Then check that the
nozzle holes are not clogged; use
a needle to unblock them if necessary.
J0A0346C
161