Advertisement
Maintenance Instructions
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy: Unplug the charger, disconnect any battery, and allow charger
to cool completely before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
1. BEFORE EAcH USE, inspect the general condition of the charger. Check for loose
hardware, misalignment or binding of moving parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces of the tool with clean cloth.
3.
WARNING! If the supply cord of this charger is damaged, it must be replaced only by a qualified
service technician. DO NOT OpEN cHARGER HOUSING, NO USER-SERVIcEABLE pARTS INSIDE.
Troubleshooting
problem
Ammeter display
Defective battery.
reads maximum.
No ammeter reading. 1. No power to engine starter.
2. Battery cables not making connection.
3. Two-amp charge rate being used.
Charging current
1. Battery is partially charged.
not to full output.
2. Defective battery, will not
Ammeter needle
1. Reversed battery connections.
moves up to full
charge, then drops
to zero. Makes
2. Battery is completely dead.
"clicking" noise.
3. Defective battery.
4. Charger Engine Starter is resetting
5. Circuit breaker is cycling.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Record product's Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually
as replacement parts. Internal parts are not user-serviceable and are not available.
Item 62292
possible causes
hold full charge.
itself after circuit overload.
For technical questions, please call 1-888-866-5797.
Likely Solutions
Check or replace battery.
1. Check power and cable outlet connections.
2. Clean battery cables and reset cable clamps.
3. None, meter will not indicate at this rate.
1. Continue charging battery.
2. Check and/or replace battery.
1. Double-check connection polarity.
If wrong, shut off charger and
correct cable lead connections.
2. Continue charging battery.
Charger will continue to reset itself until
the battery reaches a chargeable level.
3. Check and/or replace battery.
4. Wait until Charger automatically resets itself.
5. May be the wrong switch position.
Page 11
Advertisement
