System Menu - Panasonic Viera TH-32C410H Operating Instructions Manual

■
[Playing Time Display]
Set to [On] to display a continuous record of time spent
using [Game] mode in the top right of the screen every
30 minutes. [Off] / [On]
– This function is available when [Viewing Mode] is set
to [Game]. (p. 13)
■
[Radio Mode]
Sets the timer to turn off the screen automatically when
a radio channel is selected.
[Off] / [5 / 10 / 15 / 20 seconds]
– The sound is active even when the screen is off.
This function could reduce power consumption when
listening to a radio channel.
– Press any button except Standby, Volume Up / Down
and Sound Mute buttons to turn on the screen.
– Not available in Analogue TV mode.

[System Menu]

■
[Shipping Condition]
Resets all settings, including tuning data, to the original
condition.
– Access this function and follow the on-screen
instructions to complete the procedures.
– Initial Setup (p. 8) will automatically start after
[Shipping Condition] completes.
■
[System Update]
■
[Software Licence]
Displays the software licence information.
■
[System Information]
Displays the software version.
[Power Save]
Reduces brightness of picture to economise on power
consumption. [Off] / [On]
Using the [Tuning Menu]
Use the [Tuning Menu] to retune the TV automatically or
manually, add new channels, check signal conditions,
create your favourite channel lists, skip unwanted
channels, etc.
[Auto Tuning] (TV mode only)
Retunes the channels received in your area
automatically.
●
Automatically searches and adds available channels to
the memory.
●
After the scan is complete, all previously saved
channels will be erased.
Auto Tuning
Status: Scanning...
Analogue : 0
Digital : 1
Scan
EXIT
RETURN
●
When the operation is completed, the channel at the
lowest position will be displayed.
●
If tuning has not been done completely, perform
[Analogue Manual Tuning].
16
(p. 18)
5%
[Scan]
Adds new channels automatically to the channel list.
Scan
Status: Scanning...
Analogue : 0
Digital : 1
Scan
[Analogue Manual Tuning]
Sets analogue channel manually.
Analogue Manual Tuning
Searching Channels
Start Frequency (MHz)
Scan up Scan down
1
Enter the frequency to start scanning.
2
Select the scanning method.
Select
OK
• [Scan up]: Scans ascendingly from the entered
frequency to higher frequencies.
• [Scan down]: Scans descendingly from the entered
frequency to lower frequencies.
[DTMB Signal Condition]
Shows the Digital TV signal condition.
Example:
DTMB Signal Condition
Channel 40
Signal Level
Signal Condition
Bit Error Rate 0.00E-06
These bars show the maximum signal value of the
selected channel.
[DTMB Manual Tuning]
Searches for the Digital TV channels manually.
All channels found will be added to the Channel List.
Select a channel position, then start tuning.
DTMB Manual Tuning
Scan
Channel 40
Signal Level
Signal Condition
Change
OK
Access
5%
48.00
96
96
0%
96
96