Advertisement
Fokker DVIII 55"
Fokker DVIII 55"
R/C Scale Model Instructions
CONTACT INFORMATION
The Fokker DVIII was designed by M.K. Bengtson
Prototype by Edi Werner
Manufactured and Distributed by:
Bengtson Company
e-mail: sales@aerodromerc.com
Web Site: www.aerodromerc.com
Copyright© 2006-11 M. K. Bengtson
All Rights Reserved
Rev 07/11
Advertisement
Table of Contents
Related Manuals for M. K. Bengtson Fokker DVIII 55”
Summary of Contents for M. K. Bengtson Fokker DVIII 55”
- Page 1 Fokker DVIII 55” R/C Scale Model Instructions CONTACT INFORMATION The Fokker DVIII was designed by M.K. Bengtson Prototype by Edi Werner Manufactured and Distributed by: Bengtson Company e-mail: sales@aerodromerc.com Web Site: www.aerodromerc.com Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11...
- Page 2 Begin construction of the cowl by gluing C1 and C2 to a strip of 1/32” ply with the grain of the plywood running the short way. Basswood may be substituted for the 1/32” plywood. Side and Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11...
-
Page 3: Fuselage Construction
Sand the leading edge stock to be rounded and FUSELAGE CONSTRUCTION meet the ribs. The fuselage is built as two separate box structures, the front balsa sheet and ply area and the rear built up section, which are Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11... -
Page 4: Tail Surfaces
Again the LG music wires are fused in place inside the tubing with thin CA. 1/32” plywood side cheeks are attached before the front cabane music wire is glued in place as the wire must pass through a Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11... -
Page 5: Landing Gear
Use the brass hub for alignment. Epoxy the hubs in place and add a sufficient amount of epoxy around the base of the hub to reinforce the connection of the hub to the ply. Plywood Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11... - Page 6 1/8” sq. balsa reinforcement strips are attached. from 1/8” balsa and use the battery position to balance the model as shown on the plan. ASSEMBLY Balsa Pilot figure Assemble fill with foam and paint Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11...
- Page 7 Really flies a lot like my Dr.1; I just miss the other two wings. With no crosswinds, the landing was a nice float on the In the Air runway” Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11...
-
Page 8: Contact Information
Definitely not a trainer, but anybody with a bit of aileron experience should be fine. “ CONTACT INFORMATION Distributed by: Bengtson Company e-mail: sales@aerodromerc.com Web Site: www.aerodromerc.com Copyright© 2006-11 M. K. Bengtson All Rights Reserved Rev 07/11...
Need help?
Do you have a question about the Fokker DVIII 55” and is the answer not in the manual?
Questions and answers