No Water Inletting - Haier HW50-1010W Service Manual

SERVICE MANUL
HW50-1010W/HW50-1010S

10-2-2. No water inletting

Troubleshooting:
Is the tap shut off or the water pressure
too low?
N
Check if water is leaking from washer
connection, especially between inlet pipe
and tap. to make sure of no bends.
N
Check if filter of electromagnetic valve
is jammed
N
Choose pre-wash program and start，
Check if there is 220-240V at import
pin of electromagnetic valve
N
Is there open circuit
electromagnetic valve and PCB?
N
Choose pre-wash program and start，
then check if there is 220-240V at
export pin of electromagnetic valve
between
Y
Front Load Washing Machine
Open tap or wait for normal water
Y
pressure
Reconnect inlet pipe.
Y
Clean filter
Y
Replace electromagnetic valve
Y
Reconnect the wire
Replace PCB
N
２７