Addonics Technologies MFR Quick Start Manual

MFR TM
Multi Function Recorder

QUICK START GUIDE

ENG
PACKAGE CONTENTS
x1
x1
x1 x1
x1 x1
x 1 x 1
* If there are any shortages, please contact your
local dealer.
CHARGING BATTERY SET
1. Connect the battery set
with the MFR.
2. Connect the power adapter from the MFR to the
wall outlet(100-240V) to recharge the battery set.
3. The LED on the battery set
will light until the charging
finishes.
4. While charging, the MFR still can be used
as usual.
* The MFR also can work only with connected power
adapter instead of the battery set.
REMOVING BATTERY SET
1. Turn the MFR
over.
x1
2. You can see the ejector of the battery set. Push
the ejector to the right and pull the battery set to
x2
take it off.
SET BATTERIES
OF REMOTE CONTROLLER
x1
1. Remove the battery cap on the rear face of the
remote controller.
2. Insert the 2 AAA batteries
into the battery slot.
x 2
3. Recover the battery cap.
POWER ON/OFF MFR
1. You can power on/off the
MFR by the power
switch.
2. When the power switch is on, you can use the
remote controller to turn MFR off and on
again.
BACKUP DATA FROM
STORAGE CARD TO CD-R/CD-RW
1. Power on the MFR.
2. Press the ejector on the front panel to eject the
CD tray. Insert a piece of CD-R/CD-RW into the
tray and then push the tray back to close it.
After the CD tray is shut, the system will load the
disc automatically. You can read the info from the
LCD .
DISC LOADING
3. After the disc loading process(for about 10
seconds), insert the storage card you want to
backup.
OR
MultiMedia card
SecureDigital card
Type I/II CompactFlash Card
Microdrive
Memory Stick(Pro)
3.3V SmartMedia card
* The MFR allows backing up one card at one
time, so please do not insert two cards
simultaneously.
4. Press the backup key once to get ready to backup.
P ress the backup key once again to proceed and
begin backup; or press the stop key t o cancel the
process.
OR
BACKUP?
OR
BACKUP?
BEGIN
CANCEL
BEGIN
CANCEL
5. After the burning begins, you can read the burning
process on the LCD.
BURNING CD BURNING CD
00% FINISH 99% FINISH
6. The burning process is done, and the CD tray will
extract the CD-R/CD-RW automatically. Backup
completes.
* The MFR supports multi-session burning. If
there is still free space in the burned CD-R/CD-RW,
you can use it for backup again.