Touch Manual Control Pad - NewMar Scottsdale Class A 2006 Owner's Manual

Touch Manual Control Pad

To extend, press the "ON" button on the HWH control panel. The "POWER
ON" light will illuminate. Place pads under the jacks, if necessary, at this time.
A lit yellow "LEVEL" light indicates that the end, side, or corner is low. Push
an "EXTEND" (up arrow) button to extend the jack pairs according to the lit
yellow lights. Always level the vehicle from side to side before leveling the
vehicle from front to rear. Two yellow "LEVEL" lights can be on at one time.
Extend the jack pair accordingly until all yellow lights are out. If the ground is
too uneven, the jacks may not have enough stroke to level the vehicle. The
vehicle may have to be moved. After the vehicle is level, the jacks not used for
leveling may be extended until they touch the ground. This provides additional
stability against wind and activity in the vehicle. This is done by pushing the
front and/or rear "EXTEND" buttons as needed to extend any remaining jacks.
Do not use the right or left "EXTEND" button. Push the "OFF" button on the
touch panel. Turn the ignition switch off.
IMPORTANT
The leveling system should be cycled once a month or whenever the vehicle is
used to keep the system in operating condition.
To retract the jacks, turn the ignition switch "ON" but do NOT start the
engine. Press the "ON" button on the control panel one time. The "ON"
indicator light will glow steady. Press the "STORE" button. As each jack
retracts, its red "WARNING" light will go out. The vehicle can be moved as
2006 Scottsdale Class A by Newmar
6:5