Amped Wireless UA230A User Manual page 38

UA230A
The Activity LED is blinking but I cannot access the Internet.
a. You may have a mismatch in your SSID or your wireless security key. Double check the security key that
you are using for your current wireless connection. Double check that the name of the SSID is the
correct name of the network you are trying to connect to.
b. You may have an incorrect IP address assignment.

For Windows XP and 2000: Open the Amped Wireless Utility and go to the General tab. Click Renew
IP.

For Windows 7 and Vista: Open the Windows wireless utility by clicking the wireless icon on the
bottom right corner. Right click the wireless network that you are connected to and click Status.
Click diagnose to allow Windows to reset your connection.

For Mac OS X: Open the Amped Wireless Utility and disconnect from your current network. Wait
a few moments and connect again. If this does not work, unplug the USB adapter from your Mac
and plug it back in. Connect to your network again and check your Internet connection.
c. The wireless router that you are connecting to may have lost its internet connection. If possible, check
the connection between your router and the ISP.
USER'S GUIDE
37