Table of Contents
Advertisement
Input Filter and Output
Filter parameters
Use the Filter parameters to filter specific MIDI
information from the incoming or outgoing MIDI
data stream.
These parameters are helpful if you would like
VL3X to respond to certain types of information
– like program changes – but not others, such as
Continuous Controller (CC) messages.
The parameter setting you choose here tells
VL3X what not to send or respond to.
Control Change setting
All Control Change messages are filtered.
Program Change setting
All Program Change messages are filtered.
PC + CC setting
Program and Control change messages are fil-
tered.
Notes setting
(Input Channel Only)
MIDI Note information is filtered.
VL3X – Reference manual (updated 2015-07-16)
Notes + CC setting
(Input Channel Only)
MIDI Note and Control Change messages are
filtered.
Notes + PC setting
(Input Channel Only)
MIDI Note and Program Change messages are
filtered.
Notes + PC + CC setting
(Input Channel Only)
MIDI Note, Program and Control Change mes-
sages are filtered.
Transpose parameter
Use the Transpose parameter to shift incoming
MIDI note data up or down by up to 4 octaves.
If the output note after transposition falls outside
the available MIDI notes (i.e., if it is really high or
really low), the nearest octave note will be used
instead. For example, if you have set Transpose
to -4 octaves, but the note falls too far outside of
the acceptable MIDI note value range, the sys-
tem will try the next nearest transposition octave
of -3. If -3 is also too low, it will try -2 etc.
Setup
162
Advertisement
Table of Contents
