Universal Garage Door Opener - Dodge Caliber User Manual

• Pressing and holding the EVIC button once will clear the function currently being
displayed.
• To reset all resettable functions, press and release the EVIC button a second time
within three seconds of resetting the currently displayed function. Reset ALL will be
displayed during this three-second window.

UNIVERSAL GARAGE DOOR OPENER

• Place the handheld transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
transmitter button until the HomeLink
rapidly blinking light, then release both the HomeLink
buttons. This may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-trained HomeLink
constantly, programming is complete and the garage door should open.
• Your motorized door or gate will open and close while you are training the universal
transceiver. Do not train the transceiver if people or pets are in the path of the door
or gate. Only use this transceiver with a garage door opener that has a "stop and
reverse" feature as required by Federal safety standards. This includes most garage
door opener models manufactured after 1982. Do not use a garage door opener
without these safety features. Call toll-free 1–800–355–3515 or, on the Internet, at
www.HomeLink.com for safety information or assistance.
• Vehicle exhaust contains Carbon Monoxide (CO), a dangerous gas. Do not run your
vehicle in the garage while training the transceiver. Exhaust gas can cause serious
injury or death.
NOTE: If you are having difficulty training your HomeLink
was manufactured after 1995, you may have a rolling code. Follow the steps below for
Programming A Rolling Code System.
ELECTRONICS
Programming HomeLink
Begin Programming
• The HomeLink
headliner.
• Erase all channels before you begin training
by holding the two outside buttons for up to
20 seconds until the red indicator flashes.
• Park your vehicle outside of the garage and
turn the ignition switch to the ON/RUN
position.
®
indicator flash rate changes from a slow to a
®
®
button; if the indicator light stays on
WARNING!
33
®
®
buttons are located in the
®
buttons while
®
button and the handheld
and the handheld transmitter
®
and your garage door opener