Table of Contents
Advertisement
4. Top panel controls
1
2
1
Save/Recall
Press the button to recall a previously saved setting (i.e. Preset). Press and
hold down the button to save the current set-up.
Back
2
Press to return to a previous menu item/function.
Infra-red sensor
3
Receives IR commands from the supplied remote control. A clear
unobstructed line of sight between the remote control and the sensor is
required.
4
Clip
Flashes when the input to the subwoofer DSP circuitry starts to clip or
overdrive which will degrade the sound and more importantly could
damage the subwoofer/bass drivers. If this happens turn the volume down
on your connected receiver/ amplifier, rather than or the subwoofer itself,
this reduces the level at the subwoofer input rather than the output level.
5. Display
1
Notch/Boost filter 1 and 2 active.
Numeric display for volume etc.
2
3
Text display.
Refer to later sections of this manual for more information about these
adjustments and functions.
3
1
3
5
4
Power
5
Lights up bright when the subwoofer is switched "On" and dim when in
standby mode.
Selector
6
Rotate the dial to cycle through the menu item/function.
7
Enter
Press to accept the item/function highlighted in the display menu. Also
press to turn "On" when in standby mode and press and hold to put into
standby mode.
4
2
4
Units for numeric value.
5
Low pass slope.
6
Phase filter active.
6
7
5
6
5
Hide quick links:
Advertisement
Table of Contents
