Setup; Camera Setup; Connectors On The Cunima - Wige CUNIMA MCU [2] Operation Instructions Manual

3. SETUP

Please notice that due to safety reasons this camera system may only be operated by trained staff!

3.1 CAMERA SETUP

1. Open the carrying case and check if all needed items are included (see chapter 2.2).
2. Remove the power supply and connect it with the cable device to a power source (220V-
240V). The blue LED on the power supply should lighten up.
3. Connect the camera to the power supply by using the adaptor 'Fisher to XLR 7-pole'.
4. The captured image should appear at the BNC connector of the camera within seconds and
can then be finished. The setup is now completed and the camera ready for use.
Please note: do not turn the connectors when pulling out the Fisher-cable. To disconnect,
please just remove the cable by pulling straight. Turning it out with force may cause bended
connectors and lead to irreparable damage.
3.2 CONNECTORS OF THE CUNIMA
6