Table of Contents
Advertisement
To Attach The Spark Shields:
1.
A Spark Shield must be attached to both the Left Safety Guard Plate
and Right Safety Guard Plate . To do so, for each Spark Shield use two
Philips Screw , two Flat Washer , two Spring Washer , and two Hex
Nut .
(See Figure E.)
EYE SHIELD
FLEXIBLE SHAFT
FIGURE E
To Mount The Grinder On A Workbench:
1.
CAUTION! Make sure the workbench on which the Grinder will be mounted
is flat, level, and sturdy enough to support the weight of the Grinder, any
workpieces, and any additional tools.
2.
The Grinder is equipped with four Rubber Feet which allows the tool to be
temporarily placed upon a workbench for use. However, if the Grinder is to be
permanently mounted on a workbench, the Rubber Feet must be removed.
(See Assy. Diagram.)
3.
To permanently mount the Grinder on a workbench, remove the Rubber Feet
and place the Grinder in the desired work location on the workbench. Use the
four mounting holes at the Base as a template to mark the areas where four
3/16" diameter mounting holes should be drilled through the workbench.
4.
Temporarily remove the Grinder, and drill the four 3/16" diameter mounting holes
SWITCH
OF
5
SPARK SHIELD
MOVEABLE TOOL REST
Advertisement
Table of Contents
