Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. Protect others in the work area from debris such as chips and sparks. Provide barriers or shields as needed. ELECTRICAL SAFETY Grounded tools must be plugged into an outlet properly installed and grounded in accordance with all codes and ordinances.
UNPACKING When unpacking, check to make sure all the listed parts are included. If any parts are missing or broken, please call Master Quality at the number shown on the cover of this manual as soon as possible. ASSEMBLY INSTRUCTIONS WARNING! Make sure the Power Switch of the Grinder is in its “OFF”...
Page 5
To Attach The Spark Shields: A Spark Shield must be attached to both the Left Safety Guard Plate and Right Safety Guard Plate . To do so, for each Spark Shield use two Philips Screw , two Flat Washer , two Spring Washer , and two Hex Nut .
Page 6
through the workbench, making sure no hidden electric cords or cables are in the drilling path. Once the 3/16” mounting holes are drilled, align the four mounting holes at the Base of the Grinder with the four pre-drilled mounting holes in the workbench. Secure the Grinder to the workbench, using four appropriate length Bolts, Lock Washers, and Nuts (not included).
Once the grinding process is competed, turn the Power Switch of the Grinder to its “OFF” position. Do not press against the Buffing Wheel or Grinding Wheel to stop them from spinning. Allow the Wheels to completely stop on their own. Then, disconnect the Power Cord/Plug from its electrical outlet.
To clean: Wipe with a damp cloth, vacuum or use compressed air. Do not use solvents. Do not immerse any part of the Grinder in liquids. When storing: Store the Grinder in a safe, clean, dry, location out of reach of children and other unauthorized people.