Setup Options-Projector Configuration - PR XLED 590PR-8100 User Manual

SETUP OPTIONS-PROJECTOR CONFIGURATION

Projector configuration can be set conveniently via push-button switch and LCD display. Turn the projector on and the
LCD display will show the DMX address you set and saved last time and it can be reset and saved again as you please.
Launch the projector and press button ENTER for more than 5 seconds to unlock the panel, the LCD will show the
function menu of the projector, each main menu has its submenus and each submenu has a specific function. For
details, please see the "OPERATION MENU" section.
Press button UP or DOWN if you want to browse through the various Setup Options. Press button ENTER to save your
settings or enter the next menu. Press button UP or DOWN to shift.
Press button FUNC, it will return to the upper menu one by one. If you stay for minutes, it will show display status
automatically.
TO SET THE DMX START ADDRESS
Each XLED 590 must be given a DMX start address so that the correct projector responds to the correct control signals.
This DMX start address is the channel number from which the projector starts to "listen" to the digital control information
being sent out from the controller. The XLED 590 has 3 DMX modes, which are standard mode, extended mode and
short mode. For example, the standard mode has 13 channels, so set the No. 1 projector's address 001, No. 2
projector's address 014, No. 3 projector's address 027, No. 4 projector's address 040, and so on.
Launch the projector. Press button ENTER for more than 5 seconds to unlock the panel.
Press button ENTER to display DMX Address;
Press button UP and DOWN to set the address;
Press button ENTER to confirm. At the same time, the GREEN LED will flash one time. It means the setting has
been enabled.
Press button FUNC, it will return to the upper menu one by one.
6/18