Power Supply – Mains - PR XLED 590PR-8100 User Manual

CLAMP
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 4 retainers
attached to each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING on the bottom side of the fixture base as shown above) To pass the SAFETY CORD through this HOLE
for safety! Always ensure that the projector is firmly anchored to avoid vibration and slipping whilst functioning. Always
ensure that the structure that you are going to mount the projector on is secure and is strong enough to support a weight
of XLED 590.
WARNING:
1. The projector MUST NOT be lifted or carried by the clamps.
2. For safety reasons, the safety cord should afford 10 times of the unit's weight.
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Use the plug provided to connect the mains power to the projector paying attention to the voltage and frequency marked
on the panel of the projector. It is recommended that each projector be supplied separately so that they may be
individually switched on and off.
IMPORTANT
It is essential that each projector is correctly earthed and the electrical installation conforms to all relevant
standards.
Connection between the controller and a projector and between one projector and another must be made with a 2
core-screened cable, with each core having at least a 0.5mm diameter. Connection to and from the projector is via
INSTALL THE PROJECTOR
CLAMP
SAFETY CORD
HOLE FOR SAFETY CORD
POWER SUPPLY-MAINS
CONTROL CONNECTION
4/18
WARNING
To pass the SAFETY CORD
through this HOLE for safety !