PIAGGIO Beverly Tourer 125 Service Station Manual page 84

Electrical system
The battery should always be kept clean, especially on its top side, and the terminals should be coated
with Vaseline.
CAUTION
NEVER USE FUSES WITH A CAPACITY HIGHER THAN THE RECOMMENDED CAPACITY. USING
A FUSE OF UNSUITABLE RATING MAY SERIOUSLY DAMAGE THE VEHICLE OR EVEN CAUSE
A FIRE.
CAUTION
ORDINARY AND DRINKING WATER CONTAINS MINERAL SALTS THAT ARE HARMFUL FOR
THE BATTERY. FOR THIS REASON, YOU MUST ONLY USE DISTILLED WATER.
CAUTION
CHARGE THE BATTERY BEFORE USE TO ENSURE OPTIMUM PERFORMANCE. FAILURE TO
CHARGE THE BATTERY ADEQUATELY BEFORE BEING PUT INTO OPERATION WILL LEAD TO
A PREMATURE FAILURE OF THE BATTERY.
Pump electrics check
Connect the tester positive probe to pin 4 of the
connector of the fuel pump control device, and the
negative probe to pin 3, making sure there is bat-
tery voltage as indicated in the table.
Specification
Key set to «KEY ON»
Engine revs from 0 to 200 rpm
Engine revs from 200 to 1200 rpm
Engine revs from 1200 to 2000 rpm
Engine rpm ] 2000 r.p.m.
Remote controls check
To check the operation of a remote control:
1) Check that, given regular conditions, there is no
continuity between terminals 87 and 30.
2) Apply a 12V voltage to power terminals 86 and
85 of the remote control.
3) With the remote control fed, check that there is
continuity between terminals 87 and 30.
ELE SYS - 84
PUMP SUPPLY
Supply to the pump for 13 seconds
Beverly Tourer 125
Desc./Quantity
Always «OFF»
Always «ON»
0.2 seconds «ON»
9 seconds «OFF»
Always «ON»