Wall Mounting; Telephone Connection; Programming The Alarm; Program Telephone Numbers - Konig SEC-APD10 Instructions For Use

Wall Mounting:

1. Remove the back plate.
2. Mount the back plate to the desired position wall.
3. Clip the unit to the back plate.
4. Secure the PIR sensor to the back plate by fastening the screw
on the bottom.

Telephone connection:

Remove the back plate of the alarm (see figure B) and connect the
telephone cable to the alarm (6) and telephone wall socket.

Programming the alarm:

Immediately, after inserting the batteries, the 4-digit security code
must be set, simply press a desired 4 digits code onto the keypad.
Do not use "0" as the first digit for the security code, "0" is the digit
to arm the alarm.
Note: the alarm must be programmed again with the security code
each time the batteries are removed or replaced. It's not necessary
to store new telephone numbers or record a new voice message.

Program telephone numbers:

1. Press and insert the 1st telephone number.
2. Press to confirm.
3. Press for inserting 2nd telephone number.
4. Etc.
Maximum 3 telephone numbers with max 16 digits can be stored.
Note: only use friends and families telephone numbers. Do not use
emergency service numbers.
(can be used with a PABX phone system)