Jeep 2014 Wrangler User Manual page 82

ELECTRONICS
Phone Pairing
NOTE:
Pairing is a one - time initial setup before using the phone. Prior to starting the pairing
procedure ensure all additional phones within the vehicle have their Bluetooth
1. Press the "Phone"
2. Wait for the "ready" prompt and BEEP.
3. After the BEEP, say "setup" or "Uconnect device setup."
4. After the BEEP, say "device pairing."
5. After the BEEP, say "pair a device."
6. Follow the audible prompts.
• You will be asked to say a four-digit
Personal Identification Number (PIN),
which you will later need to enter into
your mobile phone. You can say any
four-digit PIN. You will not need to re-
member this PIN after the initial pairing
process.
• You will then be prompted to give the phone pairing a name (each phone paired
should have a unique name).
• Next you will be asked to give this new pairing a priority of 1 through 7 (up to seven
phones may be paired); 1 is the highest and 7 is the lowest priority. The system will
only connect to the highest priority phone that exists within the proximity of the
vehicle.
• You will then need to start the pairing procedure on your cell phone. Follow the
instructions in your cell phone Owner's Manual to complete the phone
Bluetooth ®
pairing setup.
Phonebook
Phonebook Download — Automatic Phonebook Transfer From Mobile Phone
• If equipped and specifically supported
by your phone, Uconnect
tomatically downloads names (text
names) and number entries from your
mobile phone's phonebook. Specific
Bluetooth ® Phones with Phone Book
Access Profile may support this fea-
ture. Automatic Transfer is indicated
by a green arrow at the bottom of the
screen. See www.UconnectPhone.com for supported phones.
• Automatic download and update, if supported, begins as soon as the Bluetooth
wireless phone connection is made to the Uconnect
you start the vehicle.
80
button to begin.
Phone au-
®
®
® Phone. For example, after
disabled.
®