Fault Codes; Auto Restart - Kenmore 253.76223 Use & Care Manual

ADDiTiONAL THINGS YOU SHOULD KNOW
Now that you understand the basic operation functions, here are more control features with which you should become
familiar.
The "cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents
overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility
of having to roll through to select another mode.
The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees.
If the unit is turned off in heat mode (if applicable) or fan only mode, it will return to the same setting when it is turned
on again.
When the unit is turned off in cool or energy saver mode, it will run in energy saver mode when it is turned on again, but
the setting of temperature and fan speed will remain.
Models with a key hole overflow drain hole can use drain kit 5304481680 to connect a 1/2 inch drain hose for safe
disposal of excess system water. This part can be ordered at www.SearsPartsDirect.com.
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the
other and back, press and hold both the "TEMP/TIMER" Up(A) and Down (v) buttons for 3 seconds.
FAULT CODES :
If the display reads "ES" or "AS", a sensor has failed. Contact 1-800-4-MY-HOMEQ for repair.
Evaporator coil sensor Air temperature sensor
AUTO RE-START :
After a power outage, the unit will remember the last setting and return the unit to the same setting once power is restored.
EXHAUST CONTROL :
This Exhaust Control allows the air conditioner to either recirculate inside air (CLOSED) or exhaust air to the outside
(OPEN).
The CLOSED position is used when maximum cooling is desired. It may also be used for air recirculafion without
cooling when the air conditioner is set in any FAN position.
The OPEN position removes stale air from the room and exhausts it to the outside. Fresh air is drawn in through normal
passages in the home.
4-WAY
LOUVERS
Air directional louvers control air flow direction. Your air
conditioner has the 4-way directional system described below.
The louvers will allow you to direct the air flow Up or Down
and Left or Right throughout the room as needed. Use the
central handle to adjust the air directional louvers side-to-side
until the desired Left or Right direction is obtained. Pivot
horizontal louvers with your fingertips until the desired
Up/Down direction is obtained. There are a total of 4 possible
air directional orientations available with this system.
8