Mark Sensor; Set Gap Sensor As Media Sensor And Calibrate The Gap Sensor; Skip Auto.bas - TECLABEL DT2205 User Manual

Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
IP Address
4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor
Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green/amber after 5 green blinks. (Any green/amber
will do during the 5 blinks).
The LED color will be changed as following:
Amber
red/amber (5 blinks)

4.3.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns red/amber after 5 green/amber blinks. (Any red/amber
will do during the 5 blinks).
The LED color will be changed as following:
Amber
red/amber (5 blinks)

4.3.6 Skip AUTO.BAS

TSPL2 programming language allows user to download an auto execution file to flash
memory. Printer will run the AUTO.BAS program immediately when turning on printer power.
The AUTO.BAS program can be interrupted without running the program by the power-on
utility.
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
No
DHCP
red (5 blinks) amber (5 blinks)
solid green
red (5 blinks) amber (5 blinks)
solid green
green (5 blinks)
green (5 blinks)
28
green/amber (5 blinks)
green/amber (5 blinks)