Honeywell HE360 Installation Kit page 13

Hide thumbs Also See for HE360:

Table of Contents

Available languages

IMPORTANT

All wiring must comply with applicable local code, ordinances and regula-

tions.

Wire the humidifier solenoid valve, pressure switch, humidistat and transformer. See

Fig. 13.

1. Run the two-strand thermostat wire from the humidifier to the humidistat, and

from the humidistat to the pressure switch.

2. Cut lengths of thermostat wire to reach between components, leaving adequate

wire at both ends for connections.

NOTE: Humidistat and pressure switch can be wired in any order.

3. At the humidifier, connect the black and white conductors to the two yellow

humidifier wires. (The red wires from the humidifier are not used.)

4. At the humidistat, connect both black conductors to the two humidistat terminals.

Use a wire nut to connect together the two white conductors.

5. At the pressure switch, connect the black and white conductors to the C and NO

pressure switch terminals (NC terminal is not used).

TRANSFORMER

HUMIDIFIER

SOLENOID

VALVE

Fig. 13. Wiring the controls.

HE360 HUMIDIFIER AND INSTALLATION KIT

HUMIDISTAT

AIR PRESSURE

SWITCH

M28974

69-2631ES—01

Table of Contents