Rainsense™ Ii Windshield Wipers; Heated Washer Fluid - Buick 2006 Lucerne Getting To Know Manual

Hide thumbs Also See for 2006 Lucerne:
Table of Contents

Advertisement

Getting to Know Your Lucerne
16
The rear parking assist display is located
on the rear shelf. The lights on the dis-
play provide distance information. Low-
toned beeps sound from the rear speak-
ers (for objects near the rear bumper).
See Section 3 of your Owner Manual.
Rainsense™ II Windshield
Wipers (if equipped)
The Rainsense™ II windshield wipers
use a moisture sensor to automatically
operate the wipers when needed, depend-
ing on driving conditions and the sensi-
tivity setting. If the system is left on for
long periods, an occasional wipe may
occur without any moisture on the wind-
shield to indicate the system is activated.
The headlamps and parking lamps also
will be turned on automatically when the
Rainsense wipers are active if the exteri-
or lamp control switch is in the AUTO
position.
The windshield wipers control is located
on the multifunction stalk on the left side
of the steering column. It includes the
following settings:
(Mist): Rotate the control band down
to this position to turn the wipers on for
one wipe.
(Off): Rotate the control band to this
position to turn the wipers Off.
(Sensitivity Setting): Rotate the
control band up to one of the sensitivity
levels to activate the Rainsense func-
tion. The position closest to Off is the
lowest sensitivity level.
(Low): Rotate the control band up
to this position to operate the wipers on
the Low setting.
(High): Rotate the control band up
to this position to operate the wipers on
the High setting.
(Washer Fluid): Push the paddle on
top of the multifunction lever to spray
washer fluid on the windshield.
See Section 3 of your Owner Manual.

Heated Washer Fluid

(if equipped)
Slide and release the
Washer Fluid) switch on the multifunc-
tion lever to start four automatic heated
wash/wipe cycles. The first cycle may
take up to 45 seconds to occur before
the washer fluid is heated. The remain-
ing cycles may take up to 20 seconds to
occur. The system determines the
amount of fluid and activates the wipers.
Slide and release the switch again to
cancel any remaining cycles.
See Section 3 of your Owner Manual.
(Heated

Advertisement

Table of Contents
loading

Table of Contents