Specialty Saw Clean-Cuts HYDM70-110V Instruction Manual
  1. Manuals
  2. Brands
  3. Specialty Saw Manuals
  4. Saw
  5. Clean-Cuts HYDM70-110V
  6. Instruction manual

Specialty Saw Clean-Cuts HYDM70-110V Instruction Manual

Hydraulic hose saws
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
HYDM70-110V
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Clean-Cuts HYDM70-110V and is the answer not in the manual?

Questions and answers

Related Manuals for Specialty Saw Clean-Cuts HYDM70-110V

Summary of Contents for Specialty Saw Clean-Cuts HYDM70-110V

  • Page 1 HYDM70-110V INSTRUCTION MANUAL...

  • Page 2: Table Of Contents

    INSTRUCTION MANUAL HYDM70-110V Hydraulic Hose Saw Table of Contents Introduction ......3 Old Method ....... 3 New Clean-Cuts Method .. 3 Operation ......4 Operation Procedure ..4 Changing the Blade .... 5 Vacuum Port ....... 6 Maintenance ....... 6 Benefits ......

  • Page 3: Introduction

    Introduction Clean-Cuts hydraulic hose cutting system is break-through technology using a toothed blade, cutting with the backs of each tooth, so the blade does not take a kerf. The saw bends the hose into the blade spreading the cut edges to avoid burning and smoking.

  • Page 4: Operation

    OPERATION This saw is a rugged and dependable tool when used and maintained properly. Many of these saws have been in daily service for years and are still in good working order. As with any tool, good operating procedure is important for tool life and operator safety.

  • Page 5: Changing The Blade

    Changing the Blade 1. Disconnect the saw from the power source 2. Remove all the hex nuts from the cover 3. Remove the cover. Note that when the cover is removed, the blade guard will spring forward. Remember to place it behind the cover upon reassembly.

  • Page 6: Vacuum Port

    Vacuum Port Some saw models have a vacuum port in the cover. You can attach a 2” shop vac hose to this port. If the saw and vacuum “on-off” switches are wired through one contactor, the opera- tor will be able to run both units simultaneously.

  • Page 7: Benefits

    Benefits • Cleaner Cuts • Safer Cuts • No Smoke MODEL MOTOR BLADE CUTTING CAPACITY HYDM70-110V 2 HP, 110 VAC, 1 7" OD x .093 THK X 3/4” arbor 1-1/4″ ID x 4 Wire Phase, 60 Cycle, Hydraulic Hose 3,450 RPM Hose Cutting Blades The following 5 types of blades are designed to cut hydraulic hose. If you’re not sure which is best suited to your application please call...
  • Page 8 Specialty Saw, Inc. 30 Wolcott Road Simsbury, CT 06070 USA 1-800-225-0772 Voice: (860) 658-4419 ~ Fax: (860) 651-5358 Email: info@specialtysaw.com Website: http://specialtysaw.com © Specialty Saw, Inc. 2014...

Table of Contents