1. Manuals
  2. Brands
  3. Makro Detector Manuals
  4. Metal Detector
  5. Deep Hunter
  6. User manual

Makro Detector Deephunter User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Related Manuals for Makro Detector Deephunter

Summary of Contents for Makro Detector Deephunter

  • Page 2 CAUTION! READ CAREFULLY BEFORE USING THE DEVICE! Metals w th an alloy structure (such as lead, galvan zed, etc.) wh ch have rema ned under ground for a long t me may deter orate and on occas on produce a gold e ect. Pos t ons of d erent metals under the ground e ect the sens ng of the dev ce and cause t to m s nterpret those objects as gold or prec ous.

  • Page 3: Table Of Contents

    Mode 1: Record ng and Exam n ng The Records Usage W th Mode 2 (Aud o System) Mode 2: Ground Balance Mode 2: Search and Metal Detect on Techn cal Spec f cat ons Thank You for Choosing Makro Detector.

  • Page 4: Parts And Accessor Es

    PARTS and ACCESSORIES Mode 1 - T44 Co l 36 x 44 cm (14.1 x 17.3 nches) Th s s the co l used n searches for General Purpose. User mon tors the results through the LCD d splay located on system box.
  • Page 5 PARTS and ACCESSORIES Electron c System Un t Th s s the ma n control box. On th s dev ce you w ll f nd the co l connect on, headphone jack, handset feed nlet and battery connect on. Target results are evaluated and presen- ted to user on the large color LCD D splay.
  • Page 6 PARTS and ACCESSORIES SYSTEM (CONTROL) UNIT ON/OFF BUTTON: Th s Control s used for SENSITIVITY: Th s s the Control used for turn ng the dev ce On and O . It w ll also adjust ng the sens t v ty n Mode 2. determ ne wh ch mode the dev ce w ll opera- GROUND SETTING: Th s s the adjustment te n.
  • Page 7 PARTS and ACCESSORIES HANDSET SCAN: Th s s the control for enabl ng the analys s of the target. Th s should be pressed wh le sweep ng the co l over the target to be scanned. OK: Th s s the control for conf rm ng the current funct on and sw tch ng to the upper menu.

  • Page 8: Charg Ng Battery

    CHARGING BATTERY Remove the battery from system box and connect t to the battery charg ng dev ce. The l ght on charger w ll be red dur ng charg ng and turn to green when charg ng s comple- ted.
  • Page 9 ASSEMBLY Pass the co l cable through telescop c tube. Pull the cable out from the other end of the tube. Connect the handset connect on cable w th 8 p ns to the connect on po nt at the rear of the armrest. Connect the 9-p n term nal of the co l to the COIL connector and the 8-p n term nal of handset to HAND-...

  • Page 10: Usage

    USAGE Ensure that co l always rema ns parallel to the ground dur ng searches. Fa l ng to keep the co l n a pos t on parallel to the ground may cause faulty results. WRONG RIGHT...
  • Page 11 USAGE...

  • Page 12: Usage W Th Mode 1 (V Sual System)

    USAGE w th MODE 1 (VISUAL SYSTEM) The dev ce has two separate systems. These systems are called Mode 1 and Mode 2. Turn On/O button to “Mode 1” pos t on to operate the dev ce w th the screen system. Mode 1 s the operat ng mode n wh ch the data obta ned s presented to user w th v ews and sounds.
  • Page 13 USAGE w th MODE 1 (VISUAL SYSTEM) Check ng Battery Charge Status The dev ce w ll proceed to the “Ground Balance” sect on after dent fy ng the attached co l. At the bottom of th s sect on, there s a part nd cat ng the battery status.

  • Page 14: What Is Ground Balance

    WHAT IS GROUND BALANCE Land cond t ons and so l structures may vary between reg ons (such as sandy so l, h ghly m neral zed red so l, rocks etc.). In some places, the so l structure even w th n the same reg on may often d er.

  • Page 15: Mode 1: Adjust Ng Ground Balance

    MODE 1: ADJUSTING GROUND BALANCE After the dev ce s turned On, the “GROUND BALANCE” sect on w ll appear automat cally. You should f rst check your SENSITIVITY adjustment to be able to obta n accurate results. The Sens t v ty level recommended for new users s 8.
  • Page 16 MODE 1: ADJUSTING GROUND BALANCE Reset 40 cm 3 cm Ra se the co l 40 cm above the ground. Now, keep ng the co l parallel to the ground, press the reset button and lower the co l to 3 cm. If there s ground e ect on dev ce, th s e ect w ll be seen on the “GROUND EFFECT”...

  • Page 17: Mode 1: Search And Cav Ty Detect On

    MODE 1: ADJUSTING GROUND BALANCE In the case that the ground e ect cannot be removed, reduce Sens t v ty Level by 1 ncrement and repeat the above process. 10 cm 3 cm After the e ect s completely removed, press the OK button as the co l s lowered down to 10 cm.
  • Page 18 MODE 1: SEARCH AND CAVITY DETECTION If the target s a cav ty, an ncl nat on on the “CAVITY” bar and a descend ng graph on the graph c d splay w ll be shown. The strength of the “CAVITY” bar would be shown numer cally at the top, depend ng on the target’s depth of e ect.

  • Page 19: Mode 1: Interpret Ng Osc Lloscope Data

    INTERPRETING OSCILLOSCOPE DATA The Osc lloscope s the port on of the screen where s gnals rece ved by the dev ce. These s gnals are d splayed at the top of the search screen. V ew ng th s data prov des you w th a real t me nterpretat on of the s gnals from the ground and the targets below.
  • Page 20 INTERPRETING OSCILLOSCOPE DATA If the target s a cav ty qu te close If the target s a cav ty qu te deep to surface, from surface, If the target s a p ece of metal If the target s a cav ty and very w th n a cav ty, deep from surface, If the Osc lloscope cont nuously shows a stra ght l ne;...

  • Page 21: Mode 1: El M Nat Ng Ferrous Metals

    MODE 1: ELIMINATING FERROUS METALS If the user des res, the dev ce can be adjusted to el m nate ferrous metals and not report them to the user. To use th s feature the FERROUS sett ng must be d sabled.

  • Page 22: Mode 1: Determ Nat On Of Target Depth

    DETERMINATION OF TARGET DEPTH To determ ne the depth of a target detected dur ng search: User should f rst determ ne the d mens ons of the target as re ected to the surface. For th s, br ng the co l towards the target by us ng the Target co l’s s de;...
  • Page 23 DETERMINATION OF TARGET DEPTH Max mum value that can be entered for w dth and length s 160 cm. If measured values exceed 160 cm, enter 160 cm nto the respect ve f eld and perform a depth scan. After enter ng these values, press and hold the SCAN button and sweep the co l over the target, release the SCAN button after the s gnal d sap- pears.

  • Page 24: Mode 1: Record Ng And Exam N Ng The Records

    RECORDING AND EXAMINING THE RECORDS To save the Reports obta ned: Press OK button after a the completed After obta n ng message appears on the screen to Analys s Depth nd cate that the nformat on has been Reports, press RECORD saved.

  • Page 25: Usage W Th Mode 2 (Aud O System)

    USAGE w th MODE 2 (AUDIO SYSTEM) In Mode 2, target detect on s performed w th aud o alerts only. Th s mode s recom- mended to be used for the detect on of small objects and metals such as s ngle co ns. Th s mode can be used only when Mode 2 compat ble search co ls are attached.
  • Page 26 USAGE w th MODE 2 (AUDIO SYSTEM) SENSITIVITY ADJUSTMENT SENSITIVITY Th s adjustment s used to reduce the nterference the dev ce rece ves from the surround ng env ronment due to electromagne- t c waves and the e ects from the ground. Moreover, th s s the depth adjustment of the dev ce.

  • Page 27: Mode 2: Ground Balance

    MODE 2: GROUND BALANCE GROUND BALANCE GROUND BALANCE 5 cm Br ng the Ground Balance to pos t on 1. Sweep the co l from left to r ght at 5 cm above the ground. If the dev ce rece ves any nterference, to remove t, ncrease the Ground Balance level n small ncrements wh le sweep ng the co l at the same t me.

  • Page 28: Mode 2: Search And Metal Detect On

    MODE 2: SEARCH and METAL DETECTION Hold the co l at a d stance of 5 cm from the ground. Be sure that the co l s parallel to the ground. Sweep the co l w th slow mot ons from 5 cm left to r ght for accurate target detect on.

  • Page 29: Techn Cal Spec F Cat Ons

    TECHNICAL SPECIFICATIONS MODE 1 (VISUAL SYSTEM) MODE 2 (AUDIO SYSTEM) Operat ng System Frequency 12.5 KHz 17.5 KHz Metal Detect on D splay and Sound Sound Sens t v ty Adjustment Manual Ground Balance Manual 1/4'' Stereo Headphone Output T100 Co l C47 Co l Control Un t T44 Co l...

Table of Contents