Toleranc e electric shock. junction box or cable. module surface. module. PHONO SOLAR modules do not need special cables for connection. All of the modules have permanent junction boxes, cables and connectors. Ra ted Po wer Module (IEC) Ra t...
Barcode: This is used to identify each module. Each module has a unique and traceable connectors or unplug the electrical connectors while the circuit is under load, and do serial number in the form of barcode. The barcode of each PHONO SOLAR module has 15 letter/digits.
Page 5
Barcode: This is used to identify each module. Each module has a unique and traceable When fixing the modules using the 8 mounting slots, all the hardware (washers, serial number in the form of barcode. The barcode of each PHONO SOLAR module has screws and nuts) shall be made of stainless steel;...
Page 6
2 clamps should be attached to the short sides of the module. Depending on the local wind and snow loads, additional clamps may be required. The PHONO SOLAR modules can be mounted using two methods: applied torque should be about 8Nm. Please find detailed mounting information in the...
Page 7
Stability / Reliability / Creativity (300mm) Mounting rails may run perpendicularly or parallel to the long side frame 410-490mm Mounting rails may run perpendicularly or parallel to the long side frame...
Warning: Do not attempt to drill holes in the module frame or in the glass surface of In order to reduce the risk of potential induced degradation (PID), Phono Solar strongly recommends to use anti-PID solar modules in wet regions (i.e. shores, the module.
(10) years from the date of delivery by Phono Solar to its first buyer, Phono Solar will, at its sole discretion, either The information of this instruction is from knowledge and experience of PHONO repair the defective Product(s) at no charge;...
Page 10
(1) In any event, all warranty claims must be received within the applicable warranty period for this warranty to be effective. If, within a period of Twelve (12) years from the date of delivery by Phono Solar to (2) The “Limited Product Warranties” and the ”Limited Peak Power Warranties” do not the first buyer any Product exhibits a power output less than 90% of the minimum “Peak...
Page 11
Solar. To the extent necessary for processing the return request Phono Solar or its Phono Solar, unless such other obligations or liabilities are expressly agreed to in authorized person shall be given commercially reasonable access to the Product(s) for writing signed and approved by Phono Solar to the broadest extent permitted by law.
Page 12
Product remains installed in its original location at the warranty registration. Force Majeure Phono Solar shall not be responsible or liable in any way to the customer or any third-party arising from any non-performance or delay in performance of any terms and conditions of sale, including this "Limited Warranty for PV-Modules ", due to acts...