How To Connect Your Phone - Technicolor TC8717C Setup And User Manual

2.5 How to connect your phone

Introduction
This section described how to connect the phones for single line customers.
If you have a two line setup or a setup involving a home alarm, please contact your service provider. This setup must be done by
qualified technicians.
Procedure
To set up your telephone network, follow these steps:
1 Connect your CAT-iq 2.0 compatible DECT phones to the built-in DECT base station.
For more information, see
2 Connect your traditional phone, external DECT base station or fax to the Tel1 port on the back panel of your Gateway.
Connecting a CAT-iq 2.0 phone to your Gateway
The Gateway is equipped with a DECT base station allowing you to connect up to five DECT phones. Any CAT-iq 2.0 certified
DECT phone is able to connect.
Before you can start using your CAT-iq 2.0 phone, you first have to pair it with your Gateway. Proceed as follows:
1 On the top panel of the Gateway, press and hold the Page button until the button LED starts flashing (this will take
approximately 15 seconds).
2 Put your CAT-iq 2.0 phone in pairing mode.
Consult your CAT-iq 2.0 phone's user documentation to register your CAT-iq 2.0 phone.
3 Your CAT-iq 2.0 phone prompts you that if the registration is successful, the message "Registered to base x" appears on the
screen of your CAT-iq 2.0 phone.
DMS-CTC-20131021-0004 v1.0
"Connecting a CAT-iq 2.0 phone to your Gateway" on page 27.
2 SETUP
27