LG RU-20LA80C Owner's Manual page 28

External Control Device Setup
External Control Device Setup
08. Color (Command:i)
G To adjust the screen color.
You can also adjust color in the Picture menu.
Transmission
[k][i][ ][Set ID][ ][Data][Cr]
Data Min : 0 ~ Max : 64
•
Refer to 'Real data mapping 1'. See page 27.
Acknowledgement
[i][ ][Set ID][ ][OK][Data][x]
9. Tint (Command:j)
G To adjust the screen tint.
You can also adjust tint in the Picture menu.
Transmission
[k][j][ ][Set ID][ ][Data][Cr]
Data Green : 0 ~ Red: 64
•
Refer to 'Real data mapping 1'. See page 27.
Acknowledgement
[j][ ][Set ID][ ][OK][Data][x]
10. Sharpness (Command:k)
G To adjust the screen sharpness.
You can also adjust sharpness in the Picture menu.
Transmission
[k][k][ ][Set ID][ ][Data][Cr]
Data Min: 0 ~ Max: 64
•
Refer to 'Real data mapping 1'. See page 27.
Acknowledgement
[k][ ][Set ID][ ][OK][Data][x]
11. OSD Select (Command:l)
G To select OSD (On Screen Display) mute on/off.
Transmission
[k][l][ ][Set ID][ ][Data][Cr]
Data 0: OSD mute on
Acknowledgement
[l][ ][Set ID][ ][OK][Data][x]
12. Key Lock (Command:m)
G To lock the remote control and the front panel controls on
the TV.
Transmission
[k][m][ ][Set ID][ ][Data][Cr]
Data 0: Lock off
Acknowledgement
[m][ ][Set ID][ ][OK][Data][x]
•
If you're not using the remote control and front panel controls
on the monitor, use this mode. When main power is on/off,
remote control lock is released.
28
1: OSD mute off
1: Lock on
13. Tune Command (Command:m a)
G Tune channel to following Physical/major/minor number.
Transmission
[m][a][ ][Set ID][ ][Data0][ ][Data1][Cr]
Data0: Channel Number
Min : 1 ~ Max : 0x7D(transmit by Hexadecimal code)
Data1:TV-0, CATV-1 (transmit by Hexadecimal code)
Acknowledgement
[a][ ][Set ID][ ][OK][Data0][Data1][x]
[a][ ][Set ID][ ][NG][Data0][x]
14. Channel Add/Del (Command:m b)
G To add and delete the channels.
Transmission
[m][b][ ][Set ID][ ][Data 0][Cr]
Data0: (Channel)Delete-0, (Channel)Add-1
Acknowledgement
[b][ ][Set ID][ ][OK][Data0][x]
[b][ ][Set ID][ ][NG][Data0][x]
15. Key (Command:m c)
G To send IR remote key code.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data: Key code- Refer User's Manual
Acknowledgement
[c][ ][Set ID][ ][OK][Data][x]