Panasonic KX-FLB881 Operating Instructions Manual page 75

Flatbed laser all-in-one
Table of Contents

Advertisement

11.3.6 Network
Problem
I cannot operate the following
functions.
– PC printing
– Scanning
– Remote Control
– PC FAX
– Device Monitor
The unit does not appear in
the [Select a Network Device]
dialog box when installing
Multi-Function Station.
Cause & Solution
L Confirm the LED via the LAN port of the main board. If the LED is glowing
or blinking red, the network access is working correctly.
If the LED is not glowing or blinking, confirm the LAN cable (category 5
straight cable) is connected to the LAN port of the main board correctly.
L If the LED is blinking and you cannot perform the desired operation, the IP
address of the unit may have changed.
To detect the IP address, proceed as follows.
[Start] i [All Programs] or [Programs] i [Panasonic] i the
unit's name i [IP Address Checker].
L The IP address for the unit will be detected.
Note:
L If the IP address cannot be detected, enter it manually (feature #501 on
page 61). The IP address of the computer and the unit must be in the
same local IP address class as shown below. Set the IP address in the
range of the number specified in the class corresponding to your local
network scale.
Class
Class A
Class B
Class C
*1 "xx" should be the same value for the unit and for the computer, as
shown in the following example.
Example: 172.16.0.1 - 172.16.255.254
(The available range of "xx" is 16 - 31)
*2 "xx" should be the same value for the unit and for the computer, as
shown in the following example.
Example: 192.168.0.1 - 192.168.0.254
(The available range of "xx" is 0 - 255)
L Your firewall software is blocking the connection. Disable the firewall
software or change the firewall settings to make the Multi-Function Station
work properly.
L Your firewall software is blocking the connection and the setup program may
not list any units. Consult your network administrator and temporarily
disable the firewall software.
For assistance, please visit http://www.panasonic.com/help
Subnet mask
IP address
255.0.0.0
10.0.0.1 -
10.255.255.254
255.255.0.0
172.xx.0.1 -
172.xx.255.254
255.255.255.0
192.168.xx.1 -
192.168.xx.254
11. Help
*1
*2
75

Advertisement

Table of Contents
loading

Table of Contents