Descent Control System Light; Ultrasonic Parking Sensor Light - Chevrolet Captiva Owner's Manual

4-24 Instruments and Controls
DESCENT CONTROL
SYSTEM LIGHT*
Active and Not Ready/Warning Light
The green DCS light is DCS active
indicator and the amber DCS light is
DCS not ready & warning light.
DCS active indicator illuminates (as
green colour) when DCS is ready for
use and blinks (as green colour) while
DCS is operating by pressing the DCS
button located on the centre of the
instrument panel.
DCS not ready & warning light works
as the following :
 Blinks (as amber colour) to indicate
that DCS is not ready for condition
to operate due to the high tempera-
ture (about 350~400°C) of friction
material (front pad) through severe
or repeated braking. This light will
disappear when the temperature of
friction material (front pad) is
lower than 350°C.
Illuminates (as amber colour) to

indicate that there is a malfunction
in the system due to the high
temperature (over 400°C) of friction
material (Front pad) through severe
or repeated braking.
 This light also will disappear when
temperature of friction material
(front pad) is lower than 350°C.
 The blinking and illuminating of
DCS not ready & warning light
notify you that the friction material
needs to cool down (drive your
vehicle enough without braking as
much as possible). Above tempe-
rature may differ somewhat acc-
ording to vehicle condition or env-
ironment (season or outer tempera-
ture) or etc. See Descent Control
System (DCS) on page 8-33 for
more information.
ULTRASONIC PARKING
SENSOR LIGHT
This light comes on to indicate that
there is a malfunction in the system.
 Fault due to sensors that are dirty
Covered by ice or snow

Outside ultrasonic waves interfer-

ence
The source of interference is removed,
the system will operate normally.
If the lamp does not go off, you have the
cause of the fault in the system
remedied by a CHEVROLET retailer.
See Ultrasonic Parking Assist on page
8-37 for more information.