L
Natural gas :
Make sure you have an easily accessible gas tab outside the Buzz.
Use a stability chain. This will keep the Buzz from moving and prevent damage to
the flexible hosing, for assembling you can use the holes in the bottom plate.
Disconnect the buzz if you plan to move the Buzz.
4.4 Removing front glass
Place the suction pad on the front glass. (see fig. 2.1)
Lift the glass and move the bottom side forwards towards you, the glass can now be
removed from below. (see fig. 2.2)
Replacing the glass is done in reverse order.
Remove all Fingerprints from the glass, these will be burnt into the glass when the Buzz is
in use.
4.5 Removing side glasses
Is only necessary in case of damage.
Remove the front glass.
Remove the inside bottom plate (see fig. 3.1)
Remove the burner unit (see fig. 1.6)
Place the suction pad on the glass. (see fig. 2.1)
Lift the glass, move the bottom of the glass inwards and remove the glass from
below. (see fig.2.2)
4.6
Placing the log set
Remove the front glass (see par. 4.3)
Place the log set (see fig. 3.2 or the supplied log set instruction card)
Replace the glass plate again.
7 <
<
<
<