Installation Guide; Contents; Installing The Wheels; Installation Gas Connection - Faber The Buzz Installation And User Manual

L

4 Installation guide

4.1 Contents

Remove the rear wall plate and take out loose parts from the wrapping and check the Buzz
for possible damages incurred during transport. (Report such damages to your supplier.)
You will find :
1. Two PVC wheels with fasteners (see fig. 1.1)
2. Log set
3. Instruction manual
4. Suction pad (see fig. 2.1)
5. cover
Not supplied :
1. A gas bottle with an approved gas hose with a ..... mbar pressure regulator.
(See the Technical specifics for the correct pressure)
2. Security chain.

4.2 Installing the wheels


Place the Buzz on a flat surface.

Put the bolt with the washer through the whole of the wheel and tighten it with the
black nut. Make sure that the nut is attached in such a way that there is minimal
space on the wheel and that it can still turn. Attach the wheel to the Buzz and fix it
with the lock nut. (See fig.1.1)

4.3 Installation gas connection

Please take the installation requirements into account. (chapter 3)
Propane bottle :

Open the gas bottle space by removing the access plate (see fig. 1.3 )

Attach the gas hose to the pressure regulator by means of a hose clamp.

Fix the other end in the same way to the threaded insert attached to the gas
control tap. (see fig. 1.5 B)

Remove the seal on the gas bottle.

Connect the pressure regulator to the gas bottle.

Check the entire gas connection for leakages.

Now place the gas bottle into the space and fasten it with the web sling. (see fig.
1.4 A )

The gas bottle can be opened now.
6 < < < <