Description Of Block Diagram - LG Flatron W2284F Service Manual

1. Video Controller Part.
This part amplifies the level of video signal for the digital conversion and converts from the analog video signal to the
digital video signal using a pixel clock.
The pixel clock for each mode is generated by the PLL.
The range of the pixel clock is 146MHz In W2284F.
This part consists of the Scaler, ADC convertor, TMDS receiver and LVDS transmitter.
The Scaler gets the video signal converted analog to digital, interpolates input to 1680X1050(W2284F)
resolution signal and outputs 8-bit R, G, B signal to transmitter.
2. Power Part.
This part consists of the one 3.3V, one 1.8V and one 5V regulators to convert power which is provided 5V by adapter.
12V is provided for inverter in W2284F.
Also, 5V is converted 3.3V and 1.8V by regulator. Converted power is provided for IC in the main board.
The inverter converts from DC 12V to AC 700Vrms and operates back-light lamps of module in W2284F.
3. MICOM Part.
This part is include video controller part. And this part consists of EEPROM IC , control data, Reset IC and the Micom.
The Micom distinguishes polarity and frequency of the H/V sync are supplied from signal cable.
The controlled data of each modes is stored in EEPROM.
Copyright 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes

DESCRIPTION OF BLOCK DIAGRAM

- 11 -
LGE Internal Use Only