4) Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged. In this instance, call GoFit Platinum for an inspection. 5) Do not carry this appliance by supply cord or use cord as a handle.
Replace defective components immediately and keep the equipment out of use until repair. For repairs, use only original spare parts and when in doubt, ask GoFit Platinum for advice. Only one person is permitted to use this treadmill at the same time.
BEFORE YOU BEGIN Thank you for selecting the revolutionary GoFit Silver Treadmill. The GFTMS01 offers an impressive array of features to make your home workouts more enjoyable and effective. For your benefit, read this manual carefully before using the GoFit Silver Treadmill.
ASSEMBLY STEPS CAUTION! Please follow the assembly steps below carefully and exactly to aviod injury . ALWAYS ASSEMBLE THE TREADMILL WITH AN ASSISTANT, DO NOT ATTEMPT ASSEMBLY BY ONESELF. STEP ONE Place the two computer handrail tubes of Frame (A) as shown to the right and tighten with hex screw.
Page 8
STEP THREE After left and right Uprights are tightened, cap left and right Decoration Covers (B, C) to the Frame and tighten them with Phillips Screw (C) and Plastic Washer (D). - 8 -...
Page 9
CAUTION > The cylinday contains high pressure gas. Precautions must be taken to avoid it crashing into other objects > If the cylinder is hit, it may cause damage and make the use not smooth. When the user is folding the treadmill, it may result in the falling of the frame and cause injury.
MAINTENANCE . Centering the Walking Belt. If the Walking Belt tracks off center to the right or left of the deck, first turn the power off. Then use a wrench to tighten the rear roller bolt on the side of the treadmill toward which the belt is moving.
COMPUTER INSTRUCTION Start Display: 1) If the SAFETY KEY is taken off, the matrix screen will display arrow down. If the SAFETY KEY is replaced, the matrix screen will display KGS (LBS) Weight window glitters and displays the pre-set value. The value is 70kg (150LBS) and range 23~130KG (50~286LBS).
Page 12
III. Edit Mode: 1) At Start/Ready position, press Mode to choose Manual and Program by press +/- key. 2) Program Mode: Press +/- key to edit the Program (P1~P8), and the PROGRAM 3) window will flash, LCD window will show P1~P8 to edit, you can press +/- key to edit. Press ENTER to enter the TIME edit, the Program pre-set value is 30min, Range is 20~99min, STEP is 1min.
Page 13
• When TIME is set, the window will display the countdown value from target value. When time reaches 0:00, the treadmill will stop automatically. • When TIME is not set, the window will display a positive number. When time reaches 99:00 the treadmill will stop automatically. 5) Pressing Mode key can switch between SPEED, DISTANCE, CALORIES but not INCLINE, PULSE, WEIGHT.
Page 14
PROGRAM has 30 levels in all and all the pre-set values are lowest value. After entering into the mode function, at this time, the LEVEL light is on, window flashes. This function is to select acuteness level of movement (L1~L10). You can press to change the level you need and press ENTER to make sure.
Page 15
E1: The treadmill can’t read the speed feedback value E6: Incline motor can’t work within the ADC range E7: Incline is higher or lower (Over range) ** If any error signal appears, please contact GoFit Platinum ** - 15 -...
Page 18
Trainings hints: With buying this treadmill you have taken the first step toward improving your fitness. With the help of this item you can add value to your life with improved health, wellbeing and lifestyle. Goal of training: Building of muscles General fitness Endurance Feeling of wellbeing...
Page 19
Training: Warming up should be done with every sporting activity to decrease the risk or injury. A suggested warm up is a 5-10 minute run on the spot or around the room with a few jumps at each minute interval. Stretching: The following stretches are gentle but effective in waking up your body, stimulating your circulation and making your ankles more flexible.
Need help?
Do you have a question about the Platinum GFTMS01 and is the answer not in the manual?
Questions and answers