Advertisement
2260B-GPIB-USB GPIB to USB Adapter
3. The Ready Indicator should be lit after the USB cable is connected.
Configure GPIB address from the 2260B
1. Connect a GPIB cable from a GPIB controller to the GPIB port on the adapter.
2. The display will show F-01 on the top and the configuration setting for F-01 on the bottom.
3. Rotate the voltage knob to change the F setting to F-22 (USB Mode).
4. Rotate the current knob to set the F-22 setting to 1 (Mode: GPIB-USB adapter).
5. Press the Voltage knob to save the configuration setting. ConF will be displayed when the settings are
successfully saved.
6. Rotate the voltage knob to change the F setting to F-23 (GPIB address).
2
March 2014
Advertisement
