Subscribe to Our Youtube Channel
Related Manuals for EVOKO MINTO
Summary of Contents for EVOKO MINTO
- Page 1 EVOKO MINTO CONFERENCE PHONE USER MANUAL EVOKO MINTO CONFERENCE PHONE USER MANUAL Version 1.2 www.evoko.se...
-
Page 2: Table Of Contents
Using the Evoko Minto ........................Halo light statuses ..........................Cable storage ..................... Charging & battery status .......................... Auto power off ......................More about connections ............... Configuration from the Evoko Control Panel Evoko Unlimited AB Evoko Minto Model No: EM1001 www.evoko.se... -
Page 3: Initial Configuration
To activate a backlight while charging in the Minto Wall Mount, simultaneously hold down the Bluetooth button and power button on the Evoko Minto. Do the same to deactivate. NOTE:The default backlight mode is off. NOTE: The unit can be rebooted by carefully inserting a paper clip in the hole marked with “Reset”... -
Page 4: Wall Mount Instructions
Plug in the power adapter to a proper wall outlet. Slide Minto into place by guiding it onto the back slot on the Wall Mount’s protruding top edge. When the Evoko Minto is placed on the wall mount it will automatically charge. -
Page 5: Using The Evoko Minto
To remove the Bluetooth connection, press and hold the Bluetooth button. NOTE: The default device ID is “Evoko Minto” followed by the last four digits of the serial number of the unit (which can be found on the bottom of the unit). - Page 6 NOTE: The Mute function can only be activated in case a voice connection is valid. Change the volume on the Evoko Minto or on the connected device. On the Evoko Minto, Press + to increase, - to decrease volume. Each button press increases or decreases the volume by one step.
-
Page 7: Halo Light Statuses
NOTE: Only one cable can be kept in the slot at one time. The Evoko Minto comes with the USB cable in the cable storage slot. The Audio cable can be found in the gift box. -
Page 8: Auto Power Off
You will then hear: ”Press any button to abort” . mute. However if the audio cable is removed Press any button on the Evoko Minto to abort and the Bluetooth call is still active the call will the automatic power off. If no button is pressed be resumed. -
Page 9: Configuration From The Evoko Control Panel
EVOKO MINTO CONFERENCE PHONE USER MANUAL Configuration from the Evoko Control Panel The settings in the Evoko Minto can also be changed in the Evoko Control Panel software. This is also where you do firmware upgrades. Please visit www.evoko.se/support to download the Evoko Control Panel. - Page 10 Responsible party: user’s authority to operate the equipment. Evoko Unlimited AB, c/o DMJ Technologies, Northeast Territory 2. NJ, NY Metro, 140 Henley Avenue, New Milford, NJ07646, USA. NOTE: This equipment has been tested and found to comply with Tel.+1 201 261-5560.
- Page 11 www.evoko.se...
Need help?
Do you have a question about the MINTO and is the answer not in the manual?
Questions and answers