Advertisement

EVOKO MINTO
EVOKO MINTO
A new era in phone-conferencing
USER MANUAL
1
USER MANUAL
Edition 1.7 EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EM1001 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for EVOKO EM1001

  • Page 1 EVOKO MINTO USER MANUAL EVOKO MINTO A new era in phone-conferencing USER MANUAL Edition 1.7 EN...
  • Page 2: Table Of Contents

    Using the Evoko Minto ....................... Halo light statuses ....................... Cable storage ........................Charging & battery status ....................Auto power off ........................More about connections ....................Configuration from the Evoko Control Panel ............Demo mode……..…………………………………………………………………………………..09 Evoko Unlimited AB Evoko Minto Model No: EM1001...
  • Page 3: Initial Configuration

    To activate a backlight while charging in the Minto Wall Mount, simultaneously hold down the Bluetooth button and power button on the Evoko Minto. Do the same to deactivate. NOTE:The default backlight mode is off. NOTE: The unit can be rebooted by carefully inserting a paper clip in the hole marked with “Reset”...
  • Page 4: Wall Mount Instructions

    Slide Minto into place by guiding it onto the back slot on the Wall Mount’s protruding top edge. When the Evoko Minto is placed on the wall mount it will automatically charge. When removed from the Wall Mount, voice feedback is provided on the battery status.
  • Page 5: Using The Evoko Minto

    To remove the Bluetooth connection, press and hold the Bluetooth button. NOTE: The default device ID is “Evoko Minto” followed by the last four digits of the serial number of the unit (which can be found on the bottom of the unit).
  • Page 6 To unmute, just do another Air Swipe. NOTE: The Mute function can only be activated in case a voice connection is valid. Change the volume on the Evoko Minto or on the connected device. On the Evoko Minto, press + to increase, - to decrease volume.
  • Page 7: Halo Light Statuses

    NOTE: Only one cable can be kept in the slot at one time. The Evoko Minto comes with the USB cable in the cable storage slot. The Audio cable can be found in the gift box.
  • Page 8: Auto Power Off

    “Please remove audio cable button to abort.” will be played. Press any before Bluetooth pairing” and maintain button on the Evoko Minto to abort the existing audio cable connection. automatic dis- connection. If no button is pressed within the 10 seconds, the...
  • Page 9: Configuration From The Evoko Control Panel

    A positive beep is heard when Demo Mode is activated by pressing VOL+ and BT activated. Minto starts automatically to clear the just after Power Up and when Evoko Minto is trying to Auto Pair, i.e. the memory and the Halo Light is breathing red until the blue light is blinking.
  • Page 10 EVOKO MINTO USER MANUAL Please visit www.evoko.se/support if you have any questions or need any help...
  • Page 11 (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada Hereby, Evoko Unlimited AB declares that this conference phone is in compliance with the essential requirements and other relevant provisions of directive 1999/5/EC. The declaration...
  • Page 12 www.evoko.se...

Table of Contents