Table of Contents
Advertisement
8. The Completing the Found New Hardware Wizard form is displayed when the
installation is done:
9. Click Finish to complete the hardware installation and close the wizard.
Windows then informs you that your new hardware is installed and ready to use.
NOTE: If you plug the Universe camera into a different USB 2.0 port at a later date,
you may have to repeat steps 5 through 7 above. This is typical behavior for some
versions of Windows. If the Welcome to the Found New Hardware Wizard form is not
displayed, then Windows has found the driver automatically and you should be ready to
operate the camera.
You're now ready to link the camera with the image capture application and start experimenting.
TIP: To familiarize yourself with the installation and operation of the Universe, you may
want to perform the procedures in Section 5, 6 and 7 indoors prior to your first field session.
Doing so will verify that the system and all its components have been properly installed and
are fully functional. Imaging session time is often all too limited. Test the system and learn
the basics beforehand!
MallinCam Universe - User's Guide v1.05
11
Advertisement
Table of Contents
