Mac Label - CBN CH7486E User Manual

Item
1 PHONE
1 2
2 LAN
1 2 3 4
3 RESET
4 USB
5 POWER
SWITCH
6 COAX
7 POWER

MAC Label

The CH7486E Media Access Control (MAC) label is located on the bottom of the
CH7486E. The label contains the MAC address which is a unique, 48-bit value that
identifies each Ethernet network device. To receive data service, you will need to
provide the MAC address marked HFC MAC ID to your Internet Service provider."
Note: Label may differ according to local settings or requirements.
Description
VoIP connection for a single telephone.
Use any Ethernet port to connect an Ethernet-equipped computer,
hub, bridge, or switch using an RJ-45 cable.
Activity LED - Green LED defines the activity of the Ethernet
connector.
When LED is ON, this indicates that there is no data traffic and a
connection is stabilized.
When LED is FLASHING, this indicates that there is data being
transmitted upstream or downstream.
When LED is OFF, this indicates that the unit is not powered or there
is no Ethernet connection.
Press and hold the RESET button for five seconds or longer to restore
CH7486E to factory default settings. After factory default settings
are restored, the gateway will restart and may take 5 to 30 minutes
to find and lock on the appropriate communication channels.
USB host port for print server or network storage function
Switch gear for power on/off the CH7486E.
Connect the CH7486E to a cable wall outlet.
Provide power to the CH7486E.
10