Table of Contents
Advertisement
The maximum output voltage of the system should never exceeds 240V.
WARNING
4-4. If the connected units are more than 2. Connect the "+" master output terminal of
the 3rd unit to the "－" slave output terminal of the unit 2. etc. The output voltage of
the system will be the "+" master output terminal of the 1 unit to the "－" slave output
terminal of the last unit.
5. Parallel Mode:
The power supply 3063R can be connected two or more units in parallel to obtain a
higher current output (Max. 24A only).
5-1. Set all the 3063R which will be connected in parallel operation under parallel
tracking mode as described on section 3, parallel tracking mode and adjust all units to
the same output voltage
5-2. Parallel connected the "+" master output of all unit and "－" slave output of all
units in the system.
5-3. The output voltage of the system is the same as the units been set. The output
current of the system is the sum of each unit.
The Max. output current of the parallel system should never exceeds
WARNING
24A.
6. Fixed 5V/3A output:
This is the standard 5V/3A-power output for use of TTL logic circuit. When the load
exceeds 3A, the red overload LED will light up. The output voltage will lower and the
power supply will be under C.C. mode.
C. Operation Modes of 4063R
Never switch this istrument between independent mode and tracking
WARNING
mode when this instrument is connecting with an application circuit
beacuuse this might cause damage to the unit.
To set the output mode switch(25) at:
1. Independent Mode: To set the switch at " IND " position.
2. Serial Tracking Mode: To set the switch at " SER " position.
3. Parallel Tracking Mode: To set the switch at " PAR " position.
4. Serial mode:
The power supply 4063R can be connected two or more units in series to obtain a
higher voltage output (Max. 240V).
9
DC POWER SUPPLY
st
Advertisement
Table of Contents
