Table of Contents
Advertisement
Operation Instruction
COUTION
Before operating model 3063R/4063R, please check input voltage is correct and the
ventilation holes are not been locked.
WARNING
After pressing the "SWITCH ON" button, please check the operation of
ventilation fan to avoid the instrument being over heated.
A. Setting the output voltage and output current
1.Please verify the voltage and current requirements fall within the specification of this
instrument.
2.Disconnect the circuit from the output terminal by turn the output enable switch off
(14).
3.Short the output terminal and adjust the current adjusting knob (18) to get the
minimum current for the instrument to operate under constant voltage mode which
will be indicated by the green LED.
4.Adjust the voltage adjusting knob (11) to the desired voltage setting.
[NOTE]
The power supply can automatically operate between constant voltage and constant
current by quickly responding to the load changes, when the C.C. LED(Red) light up,
the C.V. LED (green) will be off and vice versa .
B. Operation Modes of 3063R
The power supply can be operated alone or connected two or more units in serial to
obtain a higher voltage (Max. 240V). or in parallel to obtain a higher current (Max. 24A)
Never connect GND (green) terminal to any place under this operation.
WARNING
1. Independent Mode:
The master and the slave output of 3063R can be used independently to generate
voltage and current.
To operate 3063R under independent mode. Set the master output voltage/current and
slave output voltage/current as described in section A and B, model 3063R.
WARNING
Never switch this istrument between independent mode and tracking
mode when this instrument is connecting with an application circuit
beacuuse this might cause damage to the unit.
7
DC POWER SUPPLY
Advertisement
Table of Contents
