Attaching Your Telephone - AT&T UNIX Hardware Installation Manual

Installing Hardware
Attaching Your Telephone
Line 1
Line 2
Phone
1 Locate the two modular telephone cords
supplied with your UNIX PC, and remove their
plastic covers.
2 Locate your modular telephone jack.
3 Disconnect your telephone line from the
modular jack.
4 Plug the loose end of the disconnected modular
cord into the
EHQNE
connector on the back of
the UNIX PC, as shown in the following
illustration.
~-~~-~
~-~~-~
~-~~-~
~----,.-~~~~
~~~~~~
~~~~~~
,.---,~~~----,.~
5 Take one of the supplied modular telephone
cords and plug it into the modular jack where
your telephone was connected.
6 Plug the other end of the supplied modular
telephone cord into the LINE 1 connector on
the back of the UNIX PC.
13