Table of Contents
Advertisement
Precautions for Installation
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documentation.
This microphone is designed to be used
indoors.
This product is not operable outdoors.
Do not expose this microphone to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this microphone away from water and
moisture.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling or wall.
• Install the microphone in the foundation
area of the architecture or where sufficient
strength is assured.
• Do not mount this product on a plaster
board or a wooden section because they
are too weak. If this product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced or use an
optional ceiling mount bracket
(WV-Q105A).
Do not place this product in the following
places:
• Locations where it may get wet from rain or
water splash (including under the eaves, etc.)
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations where corrosive gas is pro-
duced, or locations subject to briny air
such as seashores
• Locations where the temperature is not
within the specified range (page 15)
• Locations subject to vibrations (This prod-
uct is not designed for on-vehicle use.)
• Locations subject to condensation as the
result of severe changes in temperature
(Audio may contain noise or the direction-
ality may deteriorate.)
Be sure to remove this product if it is not
in use.
Before installation
• When this microphone is mounted on a
ceiling or a wall, use the screws described
in the Installation Guide. The screws to be
used are not provided. Prepare the screws
according
to
strength and other factors of the mounting
area and the total weight of objects to be
mounted.
• Ensure that the mounting surface, anchor
and screws are sufficiently strong.
About the network connection
When connecting to a network using the net-
work cable of this product, observe the follow-
ing.
• When wiring for the network, design and
engineer wiring not to be affected by thun-
der.
the
material,
structure,
11
Advertisement
Table of Contents
